Ghostbusters Prop Utility Belt Accessories Gizmo MT500 Fobs leg hose proton pack

Ghostbusters Prop Utility Belt Accessories Gizmo MT500 Fobs leg hose proton pack

First off is the film accurate belt Gizmo. It is 100% made from scratch. I used real nixie tubes and components. It has been hand painted ,then clear coated . I used aluminum and metal to make the nixie holder. Then it was riveted to the board. The tabs on the bottom of the board are real metal. The board and chips are made from plastic. The gizmo has a blue LED in the side display box. The LED is turned on by a ON & OFF switch located on the battery casing. The battery case is easy to access and located inside the leather pouch. The LED is powered by two AA batteries (batteries are included) Gizmo comes with a leather pouch. Leather has been hand dyed and sealed with a clear coat. I also made it so you can pull the gizmo out of the leather case. I used screws instead of rivets.

*Now the Small Gizmo is a replica of the Ghostbusters 2 belt. I did my best to match every little detail ,as I did on the big gizmo. The color of the components and placement is a close as you can get to the real one. It has a leather hoop instead of a metal clip. Leather has been hand dyed then sealed. Also I used real copper rivets as they did.

*Next you have Motorola MT500 with an removable speaker mic. (

*Then two Leather Fobs. One large two part fob and one standard. (Leather has been hand dyed then sealed)

*Then you have 5 ft of yellow hose with a leather belt snap fob and leg hose connector.

2 Comments

  1. TheTXVeNoM on November 19, 2021 at 9:45 am

    Do you build and sell these?

  2. WhoYaGonnaCall on November 19, 2021 at 10:05 am

    wow awesome! 😀

Leave a Comment